View Single Post
Old 10-20-2017, 01:04 PM
mike.davison mike.davison is offline
CAMaster Owner
Join Date: Jul 2015
Location: Bolton, Massachusetts
Posts: 436

Originally Posted by Load-Ready View Post
The placard says we have a stinger, model number PT-404, yet the front of the control panel says Panther.
Mmmmm.... A PT-404 is a Panther. The 4x4 Stinger is an SR-44. Does 'placard' mean the computer screen? If so, it sounds like your WinCNC configuration needs at least one correction as what you see on the screen is highly configurable. Since this is a new machine it would be wise to speak to CAMaster support about, at least, correcting the WinCNC configuration.
Mike Davison
Stinger II 4x4, Recoil, spindle, FTC, Aspire, Sketchup
Reply With Quote