View Single Post
Old 12-18-2014, 12:11 PM
dustboy dustboy is offline
Camaster Owner
Join Date: Aug 2013
Location: San Leandro, CA
Posts: 132

I think Donnie has it right, I was reluctant to reduce the feed because this bit has to drill thousands of holes in its lifetime. My first bit lasted a year and it was still going when I replaced it.

If the last little bit is slow it shouldn't heat up too much. Is there a way to do this in Vcarve without adding a second toolpath?
Near West Cabinets

Evan Andersen

Stinger III X3
15 HP FPZ Regen Vacuum
Reply With Quote