View Single Post
  #10  
Old 05-02-2014, 08:08 PM
Mark Johnston Mark Johnston is offline
CAMaster Owner
 
Join Date: Dec 2009
Location: Prescott AZ
Posts: 822
Default

Quote:
Originally Posted by Jadendo View Post
Got it. So I would have to do 2 separate tool paths with the 2nd one -.015" offset.
Yes, but as I said you can combine the toolpaths so they run as one because your using the same bit.

Mark

If the first toolpath didn't cut all the way through the material you can have the second toolpath cut all the way through in on pass since your only removing .015.
__________________
MC4848 (mini Cobra) 48 by 48
Mach3
Aspire 8.0

Last edited by Mark Johnston; 05-02-2014 at 08:10 PM.
Reply With Quote