Errors at Initialization

[cleanest]

Been off the grid for almost 4 years and got started back up about a month ago in my hobbie shop. Going great until today when I Initialized. Got an "Aborted - Soft Limit Low X and Z." The indexer was also trying to turn which I don't think has ever happen.

I can manually move the gantry in either direction on the Y axis. Only to the right on the X axis. Z will not respond at all.

Also have the red arrow on Z in WINCNC.

Very surprised the CNC has performed as well as it has since it basically sat 4 four years. I think this is an easy fix if you know what your are doing.

Any help or advice would be greatly appreciated. Thanks RD

[drummerjg]

The red arrow in the WInCNC screen is saying you haver hit a limit switch.
I would check out the limit switches and make sure they are good as a starting point

[cleanest]

Loose cable at the CNC..................

[drummerjg]

Easy fixes are the best! Glad you’re up and running again.