CAMheads CNC Router Forum By: CAMaster CNC

Go Back   CAMheads CNC Router Forum By: CAMaster CNC > Tips & Techniques > General Discussion

Thread Tools Display Modes
Old 04-22-2016, 01:05 PM
Peterrock Peterrock is offline
CAMhead Friend
Join Date: Sep 2015
Posts: 29

The person I did this job for was aware he was going to need to clean up the coro so that was the only reason I did the job. Not worth my time to sit there and trim tiny pieces. Sanding took care of about half the junk but the leftovers would be time consuming. Luckily the aluminum composite stuff has taken over the market so you rarely run into alumacore anymore. The acm cuts nicely.
Peter Piedra

South Florida
Cobra CR-408
5 hp Spindle
Hurricane vacuum
V Carve Pro
Reply With Quote

alumacore, aluminum, coroplast

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

All times are GMT -4. The time now is 07:36 PM.

Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2018, Jelsoft Enterprises Ltd.